Der 28988 Li-ion Boe-Bot Power Pack-Charger ermöglicht bis zu 6 Stunden Betriebszeit mit zwei Akkus Bauform 18650 (nicht mitgeliefert). Die Akkus müssen zum Laden nicht entfernt werden. Ein Netzteil 1A (nicht mitgeliefert) wird über den Stecker angeschlossen.

Datenblatt: 28988-boe-bot-li-ion-powerpack-v1.0.pdf [622 KB]

Features:

Fits into the Boe-Bot’s chassis, replacing the 4-cell AA battery pack
Holds two rechargeable/replaceable 3.7 volt Li-ion 18650 cells
Provides up to 6 hours of continuous motorized operation (depending on cell capacity)
Rechargeable Li-ion cells don’t need to be removed from your Boe-Bot for recharging—charging circuitry is built into the board.
Multiple LED indicators provide charge readiness information for each individual cell; status key for the LED indicators is printed on the board.
Aggressive holders retain cells in any board orientation and in moderate shock environments, such as mobile robotic applications.
Dedicated circuitry continuously monitors the charging process to ensure safety, efficiency, and to maximize the number of charge/discharge cycles of each cell.

Kit Contents:

(1) Li-ion Boe-Bot Power-Pack / Charger PCB
(1) Li-ion battery cable
(2) 2-amp fuses; 1 pre-installed, 1 spare
(3) Hex aluminum F/M standoffs
(3) #4-40 x ¼” pan head screws
(3) #4-40 hex nuts

Key Specifications:

Charging Power Requirements: +5–12 VDC @ 1 A (min.); 2.1 mm center positive barrel jack supply
Power Output: Unregulated nominal 7.4 VDC @ 1800–2600 mAh (depending on cells used)
Dimensions: 2.65 x 3.05 x 1.00 in (7.6 x 10.2 x 2.54 cm)
Charging Time: 1 to 6 hours, depending upon the discharge level and capacity of the cells used